![]() As this is a VTOL vehicle, you must assign an RC controller switch for transitioning between multicopter and fixed-wing modes. His hobby is studying and is trying for the TOEIC (900 points).Select the airframe configuration E-flite Convergence under VTOL Tiltrotor and restart QGroundControl. Unlike complex VTOL aircraft that rotate the entire wing and require as many as four motors to achieve vertical and forward flight, the Convergence park flyer. ![]() The particular settings that are relevant to this vehicle are: That way the GPS can be put inside the body and is nicely stowed away without compromising the vehicle appearance.įollow the Standard Configuration in QGroundControl (radio, sensors, flight modes, etc.). The telemetry module fits into the bay meant to hold FPV transmission gear.įor the GPS we cut out a section of foam inside the "cockpit". If they are stable, their speed and agility is often. The flight controller can be mounted at the same place the original autopilot was. VTOL (Vertical Takeoff and Landing) RC models are usually a mixed bag when it comes to performance. Note that left and right in the configuration screen and frame reference are defined from the perspective of a human pilot inside a real plane (or looking from above, as shown below): # Flight Controller Note that you will need to start from the Generic Tiltrotor VTOL frame. The outputs are configured in the Actuators Configuration by following the instructions for VTOL tiltrotor geometry and output configuration. These can be wired to flight controller outputs more-or-less in any way you want (though outputs for motors should be grouped together, and so on). The vehicle needs 7 PWM signals for the motors and control surfaces: The Main Propeller Set: Convergence by E-flite is a quality built remote controlled airplane accessory. ![]() ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |